Ready to build a gun from scratch? Build an AR-15, AR-10, 1911, Sig P320, or Glock®-compatible handgun with your own tools and know-how? Then you need an 80% lower jig. This is the tool you'll use to machine your AR's receiver blank or your new handgun's 80% frame.
New to this project? Start here
Now that you have a basic understanding of the process, you know you need a quality, precise jig for accurately and affordably completing your receiver or frame. We offer 80% jigs that require little to no machining experience and only require basic tools -- a hand drill or drill press, a small vise, and other hand tools -- to successfully cut and drill your new firearm.
All AR-type jigs (whether you're building an AR-15, AR9, or AR-10 in aluminum or polymer) work the same: Two side plates secure the 80% lower and various top plates provide the cutting templates for cutting out the fire control cavity for the trigger, hammer, sear, disconnector, safety lever, and springs. Each side plate also has pre-drilled pin hole guides for drilling the holes required to install your lower parts kit. The AR jigs we sell are designed to work a drill press or mini-mill.
Here's how to complete an 80% lower with a jig.
Handgun jigs each work a little differently. The 1911 jig provides a carbide cutting tool for completing the slide rails and barrel seat by hand, while the P320 and Polymer80 jigs provide a template for cutting the frame with a Dremel and cutting wheel. Hand files can be used for final fitment and polishing. All handgun jigs provide pin hole templates for drilling the frames to accept parts kits and trigger components.
Contrary to federal law, some states have either restricted or banned the sale, transfer, and ownership of 80% lowers, firearm blanks, and other gun parts. Because of these restrictions, we cannot ship our products to certain states. Please confirm whether your state is restricted on our Shipping & Return Policy before placing an order. We cannot fulfill orders to restricted states if placed.
Your custom firearm build awaits.
DISCLAIMER: If you are new to the world of DIY gun building, you likely have a lot of questions and rightfully so. It’s an area that has a lot of questions that, without the correct answers, could have some serious implications. At GunBuilders.com, we are by no means providing this content on our website to serve as legal advice or legal counsel. We encourage each and every builder to perform their own research around their respective State laws as well as educating themselves on the Federal laws. When performing your own research, please be sure that you are getting your information from a reliable source.
DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither Gun Builders Depot, a/k/a GunBuilders.com nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.
We are a national retailer of individual components and not all products depicted on this website are legal in every state. Shipping of various products found on this website are prohibited to some states (such as California, Connecticut, District of Columbia, Hawaii, New Jersey, New York, Rhode Island, and Washington). The information, pictures, text or products presented on this website are not a representation by us, and should not be understood by you, that any product or completed firearm is legal to assemble or own in your state of residence. We encourage each and every builder to perform their own research about the state and federal laws that apply to them. It is your responsibility to understand the law and we encourage you to consult with an attorney or your local ATF representative.